|
|
Fire Armor
A
true three dimensional form fitting glove with curved finger design, inset thumb
with enhanced finger dexterity.
The one piece back shell is made from 100% Kevlar® knit fleece 7.5 oz. FR and water repellent fabric with exceptional flexibility across back of hand. A non-restricting Eversoft® knuckle band sewn across back for added knuckle protection. Elastic sewn into wrist crease for close fitting cuff. Back is lined with a layer of 6 oz. modacrylic non-melting and non-dripping liner. A double backed 3 mil breathable Pryotect Barricade moisture barrier 100 % water proof, viral/chemical penetration resistant, and provides blood borne pathogen protection. Barrier extends full length of glove for complete protection. The 6 oz . 65% Kevlar® and 35% Nomex® stitch bond FR liner lines the inside back of hand. Five separate finger fochettes curved and form fitted cut from 3.5 oz. to 4 oz. black flexor cowhide tanned to meet NFPA flame test for the highest finger dexterity. Special breathable adhesive is coated over entire finger, thumb and palm area, ensuring full liner/barrier/glove adhesion meets NFPA requirements for liner retention. Palm is 1 pc. 3.50 to 4.0 oz. Eversoft® cow leather tanned to meet NFPA flame resistance test and tanned with additives to stay soft when wet and low water absorbance with repeated soakings. Thumb is 2 pc. inset into palm to provide unrestricted movements of the thumb right to left. Glove liner has a 2 inch grain leather cuff sewn inside glove wrist over top of the liner for the gauntlet model and bond with 1 1/2 inch black FR binding to finish cuff. Wristlet model has a 4” Black Nomex® cuff with leather pull patch and hang up loop. This glove is sewn completely with 30/3 Kevlar® thread. This glove is NFPA 1971-2013 by the Safety Equipment Institute (SEI).
|
Copyright © 2006
David's Fire Equipment
|